ODL 17069000R Guide d'installation télécharger pdf (Page 11)

Pencil

Phillips Screwdriver

Power Saw

Hole Cutting Template

Ceiling Trim Ring

TOOLS & PARTS

Use a keyhole/drywall saw to cut the hole.

Using the correct Hole Cutting Guide for your size

tube, and a pencil, locate protruding wire in the

ceiling and trace the diameter of the ceiling inner hole

using the template marked “A”.

Slide the Trim Ring up into your ceiling hole. Make

sure the ﬂip tabs are turned in. Reach through hole

and turn ﬂip tabs out to hold ring in place.

You may have to drill a hole inside the traced diameter

circle to insert saw blade.

TIP

For 14” skylight with 16” on-center rafter

spacing, see below.

IMPORTANT

Secure the ceiling trim ring by tightening the screws.

Rafter

Traced Line

For 14” skylight with 16” on-center rafter spacing, the

14” template will draw a line that overlaps the rafters.

Be sure to adjust your cutting angle to avoid cutting into

the rafters. (See illustration)

IMPORTANT

Cut Line

Flip Tab

Trim Ring

Section-5

Inside The Room

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 62 63

Pas de commentaire

ODL 17069000R Guide d'installation Page 11